Volkswagen Touran Owners Manual: Warning and indicator lamps

Volkswagen Touran Owners Manual / While driving / Starting the engine, changing gear and parking the vehicle / Steering / Warning and indicator lamps

First read and observe the introductory information and safety warnings

Lit up	Possible cause	Correction
	Electro-mechanical steering not functioning.	The steering should be checked by a qualified workshop as soon as possible.
	Electro-mechanical steering function reduced.	The steering should be checked by a qualified workshop as soon as possible. If the yellow warning lamp remains off after the ignition has been restarted and you have driven a short distance, you do not need to consult a qualified workshop.
	The vehicle battery has been disconnected and re-connected.	Drive a short distance at a speed of 15 – 20 km/h (9 – 12 mph).

Several warning and indicator lamps will light up briefly when the ignition is switched on while the vehicle runs functional checks. They will switch off after a few seconds.

WARNING

Failure to observe the warning lamps and text messages could lead to your vehicle breaking down in traffic, accidents and serious injuries.

Never ignore warning lamps and text messages.

Stop the vehicle as soon as it is possible and safe to do so.

NOTICE

Failure to observe the warning lamps and text messages could lead to your vehicle being damaged.

Introduction

This chapter contains information on the following subjects: → Warning and indicator lamps → Information on steering The power assistance is not hydraulic. It is an electro- ...

Information on steering

First read and observe the introductory information and safety warnings The steering should be locked every time you leave vehicle to make it more difficult for break-ins to occur. Mechanical ...

Other materials:

Volkswagen Touran Owners Manual. Opening and closing the bonnet
Fig. 172 The bonnet release lever is located in the driver side footwell. Fig. 173 Release lever for opening the bonnet in the radiator grille First read and observe the introductory information and safety warnings Opening the bonnet The lever for opening the bonnet can only be operated ...

Volkswagen Touran Service Manual. Adhesive Surface Pretreatment when Replacing Laser-Soldered Roofs
Dry sand the cataphoretic primer on the roof adhesive surface -item 6- → Item down to the bare metal using P180 sandpaper. Dry sand the roof pillar adhesive surface ...